Last Modified: 11-29-2007 1.6 A
Service Category: Drivetrain Section: Automatic Transmission/Transaxle
Model Year: 2008 Model: Sequoia Doc ID: RM000002YBD00NX
Title: AB60F AUTOMATIC TRANSMISSION / TRANSAXLE: SHIFT LEVER: INSTALLATION (2008 Sequoia)

INSTALLATION

1. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY

(a) Install the transmission floor shift with the 4 bolts. Tighten the bolts in the order shown in the illustration.

Torque: 14 N·m (143 kgf·cm, 10 ft·lbf)

(b) Connect the clamp and 2 connectors.

2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Install the cable outer of the transmission control cable to the shift lever retainer, and install a new clip.

(b) Connect the transmission control cable end to the shift lever.

NOTICE:

Make sure to install the cable end so that the inner cable is not twisted. Confirm that the cable end's ridged side is facing upward.

3. INSTALL FRONT CONSOLE BOX ASSEMBLY

(a) Install the front console box assembly INTERIOR PANELS / TRIM: FRONT CONSOLE BOX: INSTALLATION (2008 Sequoia) .

4. INSPECT SHIFT LEVER POSITION AB60F AUTOMATIC TRANSMISSION / TRANSAXLE: SHIFT LEVER: ON-VEHICLE INSPECTION (2008 Sequoia)+

5. ADJUST SHIFT LEVER POSITION AB60F AUTOMATIC TRANSMISSION / TRANSAXLE: SHIFT LEVER: ADJUSTMENT (2008 Sequoia)+